Outer Limits 4x4 Board

well, after my incidents in carnage canyon, these have moved to the top of the mod list,sooooooo does anyone know any good sites to get some ideas for vit sliders and bashplates???????

antt wrote:well, after my incidents in carnage canyon, these have moved to the top of the mod list,sooooooo does anyone know any good sites to get some ideas for vit sliders and bashplates???????

Nope.

The principle and mounting points are much the same as a sierra except the bends.

Im pretty keen on a set too after some major rocker panel damage and a solid whack to my front diff in my last two outings.

I will be doing some soon... but may get them done by someone else as Im moving house in a few weeks, so can't start major surgery in the garage.


Try

http://www.off-road.com/suzuki/tech/rocker.htm

Me interested too! I made a (much-needed) bash plate for the Terios out of reenforced aluminium which I just screwed onto the licence-plate fixing points, and drilled holes in the factory bash-plate to attach it there as well. I was never meant to be very heavy-duty but it worked alright... for the Grand Vitara I had a look at where I could potentially fix any plates but haven't had time to look at it seriously yet though...

for rocker protection I have just tech screwed 2-3mm checkerplate on, then folded it under the car so it rests on the seam lip. it has taken some very serious whacks over the last 6 years and only has a couple of dens to show.

I would be looking at making it from aluminium sheet so the plate will absorb the impact rather than making them from bulletproof steel that will more than likely rip and destroy what it is attached too.

Have a look at http://www.izook.com/tech/tracker/jimmrocrails.htm for a how to on rockers, http://www.rocky-road.com/kickskid.html and http://www.puresuzuki.com/suspension1.htm for some ideas on bash plates.

thanks for that cj, these ones look like the go-> http://www.izook.com/tech/tracker/jimmrocrails.htm

bit of work in em though

antt wrote:well, after my incidents in carnage canyon, these have moved to the top of the mod list,sooooooo does anyone know any good sites to get some ideas for vit sliders and bashplates???????

I've got a good idea for sliders and bash plates...

FIT THE BASTARDS BEFORE YOU NEED THEM!!!



Do as I say, not as I do

Damo wrote:

antt wrote:well, after my incidents in carnage canyon, these have moved to the top of the mod list,sooooooo does anyone know any good sites to get some ideas for vit sliders and bashplates???????

I've got a good idea for sliders and bash plates...

FIT THE BASTARDS BEFORE YOU NEED THEM!!!



Do as I say, not as I do

Bit late for that :'(

Still bet the movies look good

When I get to see them :'(

if grimbo got his arse into gear and set up cheezy's website you would be able to check that out but when it does get finished it will be a damn good website cos it's narly taken 12 months.

now I have that off my chest cheezy uses 50mm tube and has a write up in the latest 4x4 monthly in the hardcore stuff section

I like these

Would be quite easy to make as well

bigsteve wrote:I like these

Would be quite easy to make as well

Yeah saw some similar ones.

It's basically the same design with a looped bit of round tube to make a step.

The step could be handy for sometwhere to snatch it back onto all 4 wheels after a roll