Page 1 of 1
33s under ifs 4 runner
Posted: Wed Sep 12, 2007 6:08 pm
by joey2389
hey guys just got a set of 33 inch bighorns for my car. well their in my garage atm, get fitted on friday. just woundering if i will have any guard scrubing problems. ive got 2 inch efs suspension lift and a 2 inch body lift. the front is really only 1 inch lifted so that it dosent affect the little travel i have, as much. any info would be greatly appreciated thanks.
joey2389
Posted: Thu Sep 13, 2007 7:29 am
by Struth
Depending on how wide the tyres are they may scrub a little.
I have 2" sus and 2" body lifts on the same vehicle and run 33" x 12 1/2" claws, they only ever scrub when in reverse at full lock and on uneven ground. Even then they only just touch one of the bolt heads that hold the front mud flap on.
Should be fine
Maybe you will have to dial the front up that extra 1/2" to 1" maybe not.
Cheers
Posted: Thu Sep 13, 2007 10:55 am
by Guy
Struth wrote:Depending on how wide the tyres are they may scrub a little.
I have 2" sus and 2" body lifts on the same vehicle and run 33" x 12 1/2" claws, they only ever scrub when in reverse at full lock and on uneven ground. Even then they only just touch one of the bolt heads that hold the front mud flap on.
Should be fine
Maybe you will have to dial the front up that extra 1/2" to 1" maybe not.
Cheers
Claws are notoriously short though.
Posted: Thu Sep 13, 2007 5:27 pm
by Struth
love_mud wrote:Struth wrote:Depending on how wide the tyres are they may scrub a little.
I have 2" sus and 2" body lifts on the same vehicle and run 33" x 12 1/2" claws, they only ever scrub when in reverse at full lock and on uneven ground. Even then they only just touch one of the bolt heads that hold the front mud flap on.
Should be fine
Maybe you will have to dial the front up that extra 1/2" to 1" maybe not.
Cheers
Claws are notoriously short though.
I will go and measure one and get back with an honest measurement.
Cheers
Posted: Thu Sep 13, 2007 5:36 pm
by Struth
825mm tall which is 32.5"
So the answer to your question "Get some CLAWS"
they rock and they will fit.
Cheers
Posted: Thu Sep 13, 2007 6:15 pm
by joey2389
mesured up the big horns exaxtly 33 inches on the button. they have a 50/50 chance of scrubbing. if they do scrub a grinder and a ball point hammer will fix it. prob wont need to widen wheel arch, just take a bit out on the inside of the guard which wont stand out. hopefully. i will post up a pic how it looks like now and 2morrow afternoon when tha tyres are on. thanks for your help. joey2389 cheers!
Posted: Sat Sep 15, 2007 8:32 pm
by Lux_89
I no how to fix the problem if they scrub m8, i have recip saw i can get
they wont scrub, if they dont scrub driving norm i doubt they will anywhere else purely cuz of the fact your front dsent flex-
