Page 1 of 1
4ze1 turbo
Posted: Wed Sep 19, 2007 9:43 pm
by Sterlo
Hi Guys
Anyone out there put/putting turbo on 4ze1?? Wondering weather or not to do a full engine rebuild, but only want to run around 8psi. any feed back would be greatly appreciated
Sterlo
Posted: Tue Oct 09, 2007 7:24 pm
by NICK
hi, get yourself a 4xc1 top head, loom and computer. It is a turbo piaza motor and will fit the rodeo bottom end.
NICK
turbo
Posted: Sat Oct 13, 2007 9:32 pm
by Sterlo
G'day nick
Looked at that but putting that head on the 4Ze1 accoring to my calculations will give to high of compression. Using the piaza computer/turbo etc will be to restictive on the 4ze1. I am just doing a full rebuild with all custom work. Its already bored 40thou. over.
Will use stock rods as these are cast steel, set of oversize low comp pistons, no special rings not worth it its not a drag car. Bigger injectors after market ECU wolf or microtech. Brand new garret turbo and custom manifold and i'll be happy. Not going intercooled yet will see how it goes.
Thanks Sterlo