jimney
Posted: Fri Jan 09, 2004 4:45 pm
my jimney wont engage 4 wheel drive the light on the dash flashes 4wd but nio drive to the front wheels whats up?
Page 1 of 1
Posted: Fri Jan 09, 2004 4:54 pm
perhaps if i spelt it right it would help JIMNY ,sorry lack of education
Posted: Fri Jan 09, 2004 5:33 pm
a) Its a broken. 
b) Could be the selector isn’t properly engaged? (the light is lying)
c) your hubs arnt in da locked position. Aiite
Assuming all of above is all right I’d drop it off to a dealer should still be under warranty i would have thought. Jimmmies aren’t that old yet are they?
b) Could be the selector isn’t properly engaged? (the light is lying)
c) your hubs arnt in da locked position. Aiite
Assuming all of above is all right I’d drop it off to a dealer should still be under warranty i would have thought. Jimmmies aren’t that old yet are they?
Posted: Sat Jan 10, 2004 10:51 am
truck had just come out of warranty but found prob this mornin,worked way back from transfer case and checkin front drive shaft was turnin found split in rubber hose out of manifold so vacuum wasnt engagin front hubs - cheers .
Posted: Sat Jan 10, 2004 12:12 pm
good work! 
Posted: Wed Jan 14, 2004 12:49 pm
Yup...mine did exactly the same at around the same time.....went just before an event at Zukana.
Lucky for me I still had a roll of air line from my fish tank under the seat, and Daz picked it up staright away and fixed it.
I always keep some in the toolbox now.
See...Jimnys can even be fixed with fishtank parts
Lucky for me I still had a roll of air line from my fish tank under the seat, and Daz picked it up staright away and fixed it.
I always keep some in the toolbox now.
See...Jimnys can even be fixed with fishtank parts