Page 1 of 1
Suzuki "factory" steel roll bar/hoop
Posted: Thu Sep 27, 2007 10:18 pm
by Dee
Looking for one of these standard lookin/snug fitting b pillar steel roll bars to use a base to build a 4 point from.
Were they a std. item here in Aus? Anyone know where i can get one?
yes i searched.
Posted: Fri Sep 28, 2007 8:21 am
by mugginsmoo
it looks to me as if it was a safety up-grade, in the USofA, after all the "hype" about suzukis rolling easily.
what makes me say this is that the seat-belt support bars go through the bar.
Posted: Fri Sep 28, 2007 12:02 pm
by vicelore
I would love one too... never seen them before..
Posted: Fri Sep 28, 2007 2:14 pm
by Dee
vicelore wrote:I would love one too... never seen them before..
do you mean in pictures?
or in real life? As i havent seen any zook around with one either, but see them everywhere in pics.
Really want one. Would save alot of work in building a 4 point, or even a simple 6 point, as its nice and stock looking/tight fitting, can just work straight off it.
Posted: Fri Sep 28, 2007 2:30 pm
by vicelore
i hadnt herd of any made by suzuki.. but then again iv only been into zooks for around a year. very interesting tho.
Posted: Fri Sep 28, 2007 5:34 pm
by saffrett
dont they only bolt on the top of the wheel tub that wouldnt be very strong
Posted: Fri Sep 28, 2007 8:49 pm
by foolsp33d
picked mine up for $50 bucks at the wreckers....... pics to come.. seeing as Everyone loves a pic!
Posted: Sat Sep 29, 2007 9:30 am
by NIK
My lwb had a similar one when I bought it. It looked factory as the braces that go from the targa bar down to the tub on a swb went straight to this bar. When I got my age built we chucked it as it was all rusted around the base.
Nik