Page 1 of 1
mission impossible
Posted: Fri Jan 03, 2003 12:36 am
by Hoonz
my front passanger side diff seals blew and I've pulled it all apart cleaned it repaced / and repacked all the bearings myself and put it all back together .... first time I've ever done it ...
after putting it back together I found a washer on the floor of copper/brass colour with the inside edge angled I can't remember taking it out .. can some one help me out? :(
:shocked!:
Posted: Fri Jan 03, 2003 1:02 am
by RUFF
Could be wrong but that sounds like a Brass washer from one of the Brake line fittings. Does the Brake line on a patrol caliper have a bolt going through it instead of the line screwing directly into the caliper?
Posted: Fri Jan 03, 2003 2:18 am
by big red
whats the size of it, what year is yours.
Posted: Fri Jan 03, 2003 8:14 am
by Cheezy4x4
If its a large one, around 50 to 60mm in diameter and 5mm thick its the CV spacer ring.
Posted: Fri Jan 03, 2003 8:56 am
by Hoonz
yeah its about 50-60mm diameter and 5mm thick
CV spacer?? where exactally does it go?
Posted: Fri Jan 03, 2003 9:02 am
by Juzza
On the CV shaft with the tapered side facing th cv bell.
Pull it apart again.
:(
Posted: Fri Jan 03, 2003 9:18 am
by Hoonz
DOH!!!!!!!!!!!
Posted: Fri Jan 03, 2003 3:00 pm
by bogged
Good practice...
you should time it this time to see how long it takes...
Posted: Wed Jan 08, 2003 10:51 pm
by Hoonz
didn't take me long at all .. 20mins max tyre back on
but then again I got airtools at home here