Page 1 of 1
Incab winch controller, which terminals?
Posted: Mon Oct 08, 2007 3:32 pm
by M1S3RY
When wiring an incab switch, which terminals on the control pack do you use for the in and out power?
I have wired the switch only using 3 wires (I know) one for power, one for in and one for out.
I have searched, but was unable to find exactly what i wanted to know, i think i know which ones to use but not 100%. Thanks.
Posted: Mon Oct 08, 2007 6:07 pm
by blkmav
Posted: Mon Oct 08, 2007 9:34 pm
by M1S3RY
So basically i can connect my "in" wire to any terminal with a green wire and my "out" wire to any terminal with a black wire.
Thanks.
Posted: Mon Oct 08, 2007 11:10 pm
by Cossie
M1S3RY wrote:So basically i can connect my "in" wire to any terminal with a green wire and my "out" wire to any terminal with a black wire.
Thanks.
Thats right. However it still wont work as you have the 5 pin controller, so you need to switch the earth side of the solenoids too. You should use a DPDT switch. Mine only cost $15 for a decent rocker type.
Alternatively use a seperate on/off switch for the earths.
Posted: Thu Nov 08, 2007 8:49 pm
by GQSWB42td
do you use the same wiring diagram for the 5 pin controller
Thanks Dane
Posted: Fri Nov 16, 2007 5:51 pm
by Cossie
GQSWB42td wrote:do you use the same wiring diagram for the 5 pin controller
Thanks Dane
No, its different. Have a search cos here should be one somewhere on here.
Posted: Sun Nov 18, 2007 8:34 am
by M1S3RY
5 pin diagram:
This was from memory, so i think it is correct:
