Outer Limits 4x4 Board

just doing some work to the cruiser at the moment and wanting to know where to buy the rubbers that mount the body to the chassie

thanks rob

You'd think ripco or anyother spare parts mob would have them or maybe have to go genuinne

rob dont waste ya money on originals etc,chase up some boat rollers that go on trailers,come in all different sizes and cheap for like 1 foot lenghts,just cut them to your lenght,they have ones with diff size crush tube holes in the middle too,thers a mob on ebay that have poly or rubber ones,im doin mine soon and gonna save some money,im gonna cut them half inch longer for a cheapo mini lift,got this off another forum.
cheers

davec wrote:rob dont waste ya money on originals etc,chase up some boat rollers that go on trailers,come in all different sizes and cheap for like 1 foot lenghts,just cut them to your lenght,they have ones with diff size crush tube holes in the middle too,thers a mob on ebay that have poly or rubber ones,im doin mine soon and gonna save some money,im gonna cut them half inch longer for a cheapo mini lift,got this off another forum.
cheers

Yep, did this to mine. Cost fifty bucks all up including longer high tensile bolts. I used factory rubber under the mount and boat rollers on top (what the cab sits on) I even used the factory top washer on the boat roller. It all looks factory, apart from the cab being lifted of course.

midi,how much taller then standard did ya go,im thinkin 1 inch should be ok as long as there at least the same width material.

davec wrote:midi,how much taller then standard did ya go,im thinkin 1 inch should be ok as long as there at least the same width material.

With the boat rollers I used I could get 3 mounts out of one roller. It worked out at about one and three quarter inches, but then the factory mounts are usually squased down a bit so could be closer to 2". That was for the bigger diameter mounts. I just cut the smaller mounts to suit.
Yep I reckon one inch would be fine.

cheers midi