Page 1 of 1
GQ blanking plates ( interior switches )
Posted: Mon Oct 15, 2007 10:26 am
by dwaynes
Does any one know the size of these as i want to order some switches and am hoping they fit right in.
Posted: Mon Oct 15, 2007 1:08 pm
by jet-6
Why dont you measure one?
Posted: Mon Oct 15, 2007 1:12 pm
by dwaynes
jet-6 wrote:Why dont you measure one?
because i dont have the car where i am. was hoping if the fit to order today not tomorrow. But if know one knows i will measure tonight.
Posted: Mon Oct 15, 2007 2:05 pm
by LOCKEE
The Narva Rocker switches fit, you just need to file a bit out of the dash to make the opening rectangular.
Posted: Mon Oct 15, 2007 5:19 pm
by jet-6
If there the same size as GU, yer as above, file the one corner out and Narvas fit perfect
Posted: Mon Oct 15, 2007 7:31 pm
by BowTieGQ
I didn't file mine. Just pushed firmly. But the standard Narva ones will do fine.
Posted: Mon Oct 15, 2007 9:12 pm
by dwaynes
thats okay as i measured them up
21mmx36mm roughly but thanks for the tip with the narva idea
Posted: Wed Oct 17, 2007 7:41 pm
by spannercrab
Carling Contura Rocker Switches are also a snap fit - no fiddling required
They are the same ones they use in the ARB Air Locker kits - I use them for everything, because they look so tidy, no drilling etc required.
I use the LED backlit type imported from Mouser electronics in the 'states
Posted: Fri Oct 19, 2007 11:34 pm
by MAVRK-4
Yeah any 34.5mm x 20mm Narva Switches fit perfect, the likes of:
#63010BL up to #63027BL
On page 3 of the Narva Switches listing here:
http://www.narva.com.au/Switches_11.html
I find it better not to file the corner out of the dash, switches are a lot firmer and stay in.