Outer Limits 4x4 Board

Couple of question for y'all,

1, Do WT diffs have a knuckle tube running into the diff housing and if so how far?

2, Do you think there would be enough oil flow if the centers were run upside down?

3, Are the left and right hand side knuckles inter changable? ie. running the left knuckle on the RHS and the right knuckle on the LHS?

4, How tight is the knuckle tube in the housing if there is one?

Cheers Joel

1) Yes, about 25mm

2) For anything other than crawling, no, I don't think so

3) Yes

4) Not very- It's not pressed in.

Steve.

you could relocate your fill plug but your car will still go backwards
jason

not if the engine was in the back....

I imagine Stumpy is planning some kind of buggy.

Steve.

get a coily diff

if thats the case, wouldn't it be easier to cut the hat off & rotate it 180' along with the pumpkin?

Gwagensteve wrote:not if the engine was in the back....

I imagine Stumpy is planning some kind of buggy.

Steve.

Thanks Steve,

The plan is a rear engined fun buggy.

mr green wrote:if thats the case, wouldn't it be easier to cut the hat off & rotate it 180' along with the pumpkin?

But then the pumpkin would be on the wrong side for the transfercase output shafts.

Cheers Joel