Page 1 of 1
Does this bar need modifying for blueslip in NSW?
Posted: Sat Oct 27, 2007 9:56 am
by WRXZook
I will soon be trying for a NSW blueslip and was wondering if I should extend this bar setup to the edge of the bodywork. Any legalities I should be looking at?
Thanks.
Click the image to enlarge.
Posted: Sun Oct 28, 2007 3:27 pm
by 9holes
my front bar was nearly the same as yours and mine pasted blueslip
Re: Does this bar need modifying for blueslip in NSW?
Posted: Sun Oct 28, 2007 5:02 pm
by andrew e
WRXZook wrote:I will soon be trying for a NSW blueslip and was wondering if I should extend this bar setup to the edge of the bodywork. Any legalities I should be looking at?
yes, no sharp edges. 25mm radius on edges i was told. However if your blueslip bloke turns a blind eye to the grooved tyres, the bar should be no problem.
Posted: Sun Oct 28, 2007 9:21 pm
by WRXZook
Thanks for the replies, I'm looking forward to getting it on the road. Just need a bit more time to finish a couple more things.
Posted: Sun Oct 28, 2007 10:36 pm
by xenith
mate i got pined the other day for exposed box section of chassis to the front
and told to cover it with plate to pass blue slip other wise all most same bar
Posted: Mon Oct 29, 2007 4:32 pm
by WRXZook
Thanks, I was wondering about that. I'll cover the chassis ends.
