My first post and question, while I sift through the torrent of information on the bible.
I resurfaced the cylinder head on my Patrol GU TB45 a couple of months ago and over the past week its been overheating. with the help of a mates "endoscope" I can see signs of water incursion on two of the cylinders. Exhaust is burning too lean as well. Head came off and two of the valves are burnt as well.
Since reconditioned/exchange heads aren't available where I currently live (United Arab Emirates), I'll have to go for a new head.
But before I mess up again I need to know the tightening sequence, torque and angles on a TB45 cylinder head. The local dealer was unhelpful.
Any printables for the TB45 would be even better. can't find anything online. Nothing on the TB45 in Alldata or Haynes either.
Many thanks.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
TB45 cylinder Head replacement
Who is online
Users browsing this forum: No registered users and 14 guests