Outer Limits 4x4 Board

I know this has been discussed in other threads and I have had a read, mainly about actually new mounts that go onto the actual transfer case. What have people done to fix the actual mounts on the chassis to stop them from bending. Has anyone cut them of and started over pics would be awesome...? I am currently running the Spidertrax mounts which are great but have obviously moved the weak spot to th chassis.

I have read this thread
http://www.outerlimits4x4.com/phpBB2/vi ... ase+mounts

This is what Im talking about fixing red circled area. I have ripped mine and a fix is in order

Quick update for those that may need the info for the future...

Have used 8mm plate 75mm wide 130mm long (50mm chassis width the rest used to make the distance out from the original holes measured from the original brackets). Cut the old bottom brackets that had cracked and broken of and replaced with new plate using the gusseting on the inside of the chassis for the support. WE added a bit of filling plate to get the extra hight to match up to the supports and new Spidertrax brackets which hopefully wont twist like factory ones....?

Heres some picks. As you will notice transfer case was pulled for this job



Old and new




Keeping the lines out the way

And finally painted, all though from painting and getting the camera all ready copped dirt on them.....

Mine.

Nice ...lol where were you last week when I needed ideas.......

MUD-PIGSIERRA wrote:Nice ...lol where were you last week when I needed ideas.......

Lying under a zook ofcoarse

have u lifted ur case Gutless? if so how far

Gutless

Dude... Like that work you did. It looks like you raised the T case? How much? did you clock it also? Did you have to midify the floor and shifter hole throught the floor?



Rich

Its lifted 30mm, and rotated less than 10 degrees. Gave me more room for a muffler to be mounted above the bash gaurd.

Did you have to modify the floor?

txzuk1988 wrote:Did you have to modify the floor?

Nope. 30mm body lift