Outer Limits 4x4 Board

Where do i pick up the oil to run oil lines to the turbo?

and where would i send it back to ?

Cheers for the help ......

Cut hole in side of sump just below bolts. Weld in 25-30mm dia tube say 40mm long. Thats the drain, then "T" into the vac pump oil line OR i think there is another gallery plug just near it about 70mm further back along the block.

Hope this point you in the right direction, lilttle tight on time for detail



Sterlo

cheers just find this out then when i get the set up it sshould be smooth sailing

wow man, your plumbing a turbo on a standard sd33? nice work man.. how far along are you?

IF someone can remind me, i can take a pic of the side of a turbo block with turbo stilll attached and put it up

Ill most likely to forget though

CHeers

Vanne wrote:wow man, your plumbing a turbo on a standard sd33? nice work man.. how far along are you?

Not yet just in the planning want to get every thing in place then the turbo!!!
Then i think not sure 315 75 16 MTZ and with my two inch springs i should be pretty happy me thinks

on my sd 33 it used the oil feed and return that goes into the back of the alternator (oil pump) 2 x T's one on the feed and one on the return and she is done

i'm taking it that the turbo does not need a lot of oil if it's coming of the back of the alternator ? or does the alt have a fair bit of oil pumped into the back of it.

i assume both i got mine like this and have never had any issues... though the piping i have from my oil feed to the turbo is almost haft that of the oil feed to the alt

as i said remind me, im pissed as a nute otherwise id do it now


Im happy to help but annoy the shit outta me till i do or youll go without

pongo wrote:as i said remind me, im pissed as a nute otherwise id do it now


Im happy to help but annoy the shit outta me till i do or youll go without

Ok any help would be great pics??????????? i'll send another message tomorrow