Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

this may sound dumb suspension setup

Tech Talk for Ford, Mazda, Daihatsu & Makes that currently dont have a home.

Moderator: Tiny

Post Reply
Posts: 459
Joined: Sat Jul 29, 2006 8:39 pm
Location: brisbane (boganhole)

this may sound dumb suspension setup

Post by short stuff »

could you put coil overs in the front of the feroza in the same place as the standard shock. so that you get the ride height without a rough ride
Posts: 136
Joined: Tue Nov 27, 2007 7:58 am
Location: Whangarei NZ

Re: this may sound dumb suspension setup

Post by meece4x4 »

short stuff wrote:could you put coil overs in the front of the feroza in the same place as the standard shock. so that you get the ride height without a rough ride
dont have an answer for the coil over ..sounds like a cool idea ...however there are a few things that improve the standard ride no end

Hilux rear springs give a 2" ride height but are softer (if you take out a couple of the springs) so i have a softer ride than factory 2" lift AND far more articulation I replaced the shocks in mine with modified VN Comadore ones that are a couple of inches longer than the Fez ones and nice and soft.

As for the front best thing you can do is ditch the swaybar .. It's unbeleivable how much that dam thing affects the ride (for the worse!) Since removing it and winding up the front bars 2" I have a slightly firmer ride in the nose (this offsets the lack of a swaybar on corners) WAY more articulation in the IRS and with a decent set of aftermarket shocks in the nose I have a softer than factory ride ..way more articualtion and all round better on and off road manners.

Since doing these mods the Feroza has lost that harsh pitching and bouncing on the open road and the nose dosnt become skippy when one wheel hits a pothole the IR$S now acts like IRS rather than transfering the bump through the whole front end.. dosnt feel like a lowered boyracer car with illegal cut springs anymore :lol:

Might be a cheaper and easier way to get a better ride than modifing the nose then getting certification etc.

Cheers Meece
_________________
1988 LWB ,IFS, LSD, POS, PAJ, 31" M/T's on bling rims, Snorkel, 2" Lift ,new shocks ,XD9000 winch
Posts: 81
Joined: Sun Sep 30, 2007 7:59 am
Location: oregon

Re: this may sound dumb suspension setup

Post by stariondriver »

short stuff wrote:could you put coil overs in the front of the feroza in the same place as the standard shock. so that you get the ride height without a rough ride
if the feroza is the same as the us rocky then yes. but i think the us rocky is the feroza widetrack
i had the same idea for my rocky as a alternative for turning up the torsion bars
Posts: 222
Joined: Thu Jul 24, 2003 9:26 pm
Location: Boyne Island (Near Gladstone)

Post by Clint »

There is some discussion on this topic here
http://carl.outerlimits4x4.com/viewtopi ... highlight=
Clint,
Limited Edition 95 Roza & 2006 ST Patrol Coil Cab Ute.... both a work in progress.
Posts: 459
Joined: Sat Jul 29, 2006 8:39 pm
Location: brisbane (boganhole)

Post by short stuff »

thanks ill have to look into that
Posts: 2297
Joined: Mon Mar 06, 2006 1:23 pm
Location: Melbourne-Australia

Post by MightyMouse »

Your not going to change the fundamental limits of the Feroza by putting on coil overs as its not the springs that limit the travel / height its the control arms and chassis.

You could however increase the existing spring rate if you wanted too.

Things are also tight in the front arm area and the chassis is not really designed to feed spring loads into that area so IMO a fair amount of fabrication would be necessary.

However coils could be rising rate - something that isn't really possible with torsion bars.

For all the messing around , pneumatic bump stops would probably be just as good and a hell of a lot simpler.
( usual disclaimers )

It seemed like a much better idea when I started it than it does now.
Posts: 81
Joined: Sun Sep 30, 2007 7:59 am
Location: oregon

Post by stariondriver »

only thing i see coilovers helping with is raising the front 1-2 inch without making is super stiff to the pint og loosing front wheel travel.
Posts: 2297
Joined: Mon Mar 06, 2006 1:23 pm
Location: Melbourne-Australia

Post by MightyMouse »

but if you raise the front you do loose droop travel. Overall nothing changes its just you have more bump and less droop.

Its the lack of droop that really hurts standard Feroza's so it looks cool but hurts

Doesnt matter how you add the extra springiness, raising means pushing the control arms down and there goes the droop travel.

Assuming no one has "redesigned" the front suspension :D
( usual disclaimers )

It seemed like a much better idea when I started it than it does now.
Posts: 136
Joined: Tue Nov 27, 2007 7:58 am
Location: Whangarei NZ

Post by meece4x4 »

MightyMouse wrote:but if you raise the front you do loose droop travel. Overall nothing changes its just you have more bump and less droop.

Its the lack of droop that really hurts standard Feroza's so it looks cool but hurts

Doesnt matter how you add the extra springiness, raising means pushing the control arms down and there goes the droop travel.

Assuming no one has "redesigned" the front suspension :D
I raised mine 2" for chassis clearance .. by shaving the bump stops i regained prob an 1" back of downward droop and still have a safe angle for the CV's.

Most of 4wd'ing I do in NZ requires ground clearance rather than articulation (up the back of the farm in the muddy paddocks and on the beach so a lack of downward travel and a very marginal higher COG isnt too much of a concern (Dropping 350Kg out of the cabin in weight has lowered the COG anyway I would think)

the inch i loose on the front is partly made up with the 3 or 4 inches more articulation that the rear can do now with the modified hilux/commadore/homemade shakels gear over the standard springs/shocks/shakels ..

I think with most things ... modify ya 4by to the style or useage you want to use it for. If I wanted a 4x4 with massive flex I would just go out and buy a Rangie *shudder* :D .. The small Feroza suits my needs (and my midlife crisis the fact that it's a converable) for the moment :lol:
_________________
1988 LWB ,IFS, LSD, POS, PAJ, 31" M/T's on bling rims, Snorkel, 2" Lift ,new shocks ,XD9000 winch
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests