Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

holley on gas

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 238
Joined: Sun May 07, 2006 7:37 pm
Location: Pakenham

holley on gas

Post by seaeagle »

can any carbie be used on gas/fuel , is there anything need to be done or can it go straight on?
Top
Posts: 1258
Joined: Wed Mar 21, 2007 7:49 pm
Location: Mornington/ Victoria

Contact:
Contact PGS 4WD

Post by PGS 4WD »

Holley is generally Ok, Thermoquads are no good (made of bakelight), quaddies are hard to get in good condition (most of the rebuilt ones I've see are far from it) and take longer to tune, also if fitting a side mount impco then you need to brace it or the centre stud gets pulled out over time jamming the secondary air valve. Holley make a good offroad carby too with dampened floats and modified vent tubes.

Joel
-Pre trip inspections/ servicing
-Suspension/ custom modifications
-4wd Dyno & tuning
-Qualified mechanics
Top
Posts: 96
Joined: Mon Apr 03, 2006 6:47 pm
Location: Melbourne

Post by shrekman »

Also with a holley make sure you remove the choke butterfly and linkages and seal the hole.
If I cant drive it, drink it, build it or bang it I dont care about it!!
Top
Posts: 238
Joined: Sun May 07, 2006 7:37 pm
Location: Pakenham

Post by seaeagle »

missed it by $2 on an ebay war........
Top
Posts: 1258
Joined: Wed Mar 21, 2007 7:49 pm
Location: Mornington/ Victoria

Contact:
Contact PGS 4WD

Post by PGS 4WD »

shrekman wrote:Also with a holley make sure you remove the choke butterfly and linkages and seal the hole.
Why??

I just back the choke off if it is and electric one so you can keep the cold fast idle.

Joel
-Pre trip inspections/ servicing
-Suspension/ custom modifications
-4wd Dyno & tuning
-Qualified mechanics
Top
Posts: 84
Joined: Fri Feb 03, 2006 10:19 pm
Location: medowie

Post by dv8666 »

shrekman wrote:Also with a holley make sure you remove the choke butterfly and linkages and seal the hole.
This may be an answer to the pain in my ass
The Holley I have fitted was already missing the choke assy, has a sprint gas mixer (i think). At idle it seems to have a vacuum leak, poor brake performance, lumpy idle (but does have a biiiig cam) Give it some revs in neutral and it won't idle down. Does this hole where the choke linkage goes cause this problem or am I off track? I would just go fire it up and block the hole but the starter is out right now...
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 1 guest