Outer Limits 4x4 Board

Hello
does anybody know what length power steering pressure hose is needed when fitting a VP ser2 3.8 into a LN106?

Thanks, jesse

I just checked mine and its 600mm in lenght, I got made up at ENZED can't remember how much. I'm about to plumb in a oil cooler on the low pressure side as I have it runs pretty hot when 4wheelin all day( I only run 33's) Mark

I think a better way of doing it is to use your existing Hi-press Hilux steel tube to the box and rotate it to go forward and easy bend down beside the box, then at the bottom, a bend so it faces backwards pointing to under the V6 oil filter. To that, get a fitting braized to it to couple to a fitting on the V6 pump flex tube you already should have. No extra pipes are required. I think that's how I did mine and it's still good after 12 years, except the Comm hose perished from the heat, but that was easily replaced.

Pics;

Looking down at back of pump


Looking up from under radiator


Looking down from top of radiator


Looking down from top of radiator

surfseller06 wrote:I just checked mine and its 600mm in lenght, I got made up at ENZED can't remember how much. I'm about to plumb in a oil cooler on the low pressure side as I have it runs pretty hot when 4wheelin all day( I only run 33's) Mark

Just flexible stuff with the correct fittings on it?

Same issue for me

surfseller06 wrote:
I just checked mine and its 600mm in lenght, I got made up at ENZED can't remember how much. I'm about to plumb in a oil cooler on the low pressure side as I have it runs pretty hot when 4wheelin all day( I only run 33's) Mark


Just flexible stuff with the correct fittings on it?

Same issue for me

thanks thats what i was after
is there a 90 degree fitting on either end or its all just striaght?

When I make hoses for commodore series 2 to hilux the hose is about 290 mm long with right angle fittings and nipples in the P/S pump and steering box

Sounds like luxadore wants some Power Steering Hose BLING.

The longer the better it looks!