Outer Limits 4x4 Board

Does any one in the brisbane area know of a decent panel beater. Want to get the rear guards cut to fit the 34's under the 4runner.
Gone to a couple round the bowen hills area and they don't want to touch it or want to charge a $400 a side to do it.
Preferably near bowen hills or mount gravatt area. And one that maybe works on 4wd's.

basketcase wrote:Does any one in the brisbane area know of a decent panel beater. Want to get the rear guards cut to fit the 34's under the 4runner.
Gone to a couple round the bowen hills area and they don't want to touch it or want to charge a $400 a side to do it.
Preferably near bowen hills or mount gravatt area. And one that maybe works on 4wd's.

IMO that is not really a bad price. I did get mine for alot less (but I got a good deal). Remeber they need to re-make the inner fender.

I had the same response. I got a quote for $5000 to get the front and rear done. I did not get it done at that place

You would be better off getting a 4wd mod place to do the job as they don't question the reason for doing it, like most other places.

Chris.

PM'd you.

Try Pine City Smash on the norfside mate

They don't mind little jobs, they're doin some rust in my spook for around $300. That's a good $100-150 cheaper than I could get elsehwere.

My mechanic recommended em to me. PM me if you want their no.

You could try Silver Star out at Wynnum. Until recently he had quite a nice black Wrangler, and doesn't mind the occasional different job.

Scott

Thanks for that guys. Pine Rivers and Wynnum are a tad far with work and TAFE. Might go check them out if nothing works out in my area.