Page 1 of 1

mk uni joint grease nipples???

Posted: Sun Dec 16, 2007 5:30 pm
by 4WD WOG
hey guys,

my uni joint on the rear drive shaft of my shorty mk was squeaking so i took it off cause i knew it had no grease nipples on it for some reason.

its got the threaded hole for them so i went to repco and bought a couple, put them in but the problem is u cant get a grease gun nipple in there so how the $%&* are u suppose to grease them???

Posted: Sun Dec 16, 2007 6:46 pm
by outback_pootrol
jack tha ass end up really high whilst leaving the wheels on the ground, and that should make the opening open right up so you can get it in there,

Posted: Sun Dec 16, 2007 7:32 pm
by 4WD WOG
i have the whole drive shaft off the car and still cant get the grease gun over the nipple

Posted: Sun Dec 16, 2007 7:36 pm
by pongo
you need to buy an adapter, only heard of them, never seen them.


Or, buy a uni that has a grease nipple in one of the caps

Posted: Sun Dec 16, 2007 7:47 pm
by 4WD WOG
is it possible to get longer nipples?

Posted: Sun Dec 16, 2007 8:41 pm
by GT60
You can get longer nipples 45 or 90 degree one's etc.

Posted: Mon Dec 17, 2007 8:08 pm
by MQfishbucket
Nipples come in all shapes and sizes... seriously though I put long ones on my MK shorty- they look as if they would get pinched in the joint but they don't, and the grease gun gets to them easily.

Posted: Mon Dec 17, 2007 8:34 pm
by 4WD WOG
got some today guys from brisbane air cleaners, all good, much longer and easy to grease, turns out i need a new uni cause its ceased so im 1 nipple up