Outer Limits 4x4 Board

on the hunt for a set of steel rims, options of neg 24 or zero or should i be lookin for some in between

there going to be holding 33x12.5s

93 gen 2 lwb flared pajero


wanting a quick idea of what offsets you all prefure since there seens to be a larger amount of pajero owners on outer limits

thanks guys
much appretiated
sam.

Zero offset helps return the scrub radius to where it needs to be.

-Scott- wrote:Zero offset helps return the scrub radius to where it needs to be.

Would not the offset rims be better for the wider tyres, or do you think you can get away with it?

To far and they really scrub on the back of the flares when turning on the front wheels.

That is what I found with Toyo Cruiser rims.

NJ

NJV6 wrote:To far and they really scrub on the back of the flares when turning on the front wheels.

That is what I found with Toyo Cruiser rims.

NJ

Is that not mostly caused by the larger tyres eg: 33x12.5 as stated?

Well I tried them on 285/75/16 and 255/75/16. both in BFG MT and both measure taller than 33 x 12.5. The 285 being about an inch narrower, and the 255 being more than 2 inchs narrower.

They were however both on 8 inch rims.

Wat about running 31 x 10.5 on toyota offset rims?? will that put to much strain on suspension, sterring components etc.. and is there any scrubing??
Thanks

4x4 suzi wrote:Wat about running 31 x 10.5 on toyota offset rims?? will that put to much strain on suspension, sterring components etc.. and is there any scrubing??
Thanks

31x10.5 will fit the standard Pajero 15x7 rims without any trouble.

ive used -27 mags 15x8 and 31s on them and had no worries and i had no lift at the time

its all been talked about before
http://www.outerlimits4x4.com/PHP_Modul ... highlight=
search is your friend