Outer Limits 4x4 Board

I was bored and thought I would remove the wiper arms on the cruiser and give them a coat of paint, all was going good until I was putting the passenger side arm back on and when tightening the nut that holds the arm down must have gone a bit hard and now it wont go tight enough. I tried thread tape but with no joy.

I only hope its just he nut that is stripped and a trip to the wreckers will solve the problem, if its the thread on the shaft on the motor I am not sure what to do, am I up for another motor or is the shaft bit replacable?

Damn nuts have to be some custom job too - typical

if the nut is strip then replace it if the shaft is then see if there is any thread on shaft if so put washer between the nut and wiper arm

pm surfection
Jeremy and Emma should have a ute by now.

dow50r wrote:pm surfection
Jeremy and Emma should have a ute by now.

Im confused

whiteknight wrote:

dow50r wrote:pm surfection
Jeremy and Emma should have a ute by now.

Im confused

I am guessing he is saying that the wiper off the rear window has the part you are after.

Nah I checked for that when I first striped it, the raer wipers have a standard nut. And to make matters worst I was going to try the washer under the nut idea but now the nut has rattled loose while driving and its gone :(

Off to the wreckers for me on the weekend i guess..

Jeremy and Emmas' std cruiser is in being cut into a uterus, they will have some spare rear door parts if you need them....