Page 1 of 1
turbo probs 2.8 lux
Posted: Sat Jan 05, 2008 4:55 pm
by lux2.8
hey all just installed a turbo of a 2lte surf on my 91 2.8d hilux umm drove it currentley pulling 6 pound but the oil pressure is way high it dont move we had to rotate the turbo so it could fit and had to re weld the waste gate controller so it would work could this be it or is there something else in the game any suggestions would be great thanks.
Posted: Sat Jan 05, 2008 5:36 pm
by ferrit
one of our CFS trucks has oil pressure off the scale on the gauge.
its because its got a broken ring and every time that cylinder fires, it pressurises the crankcase.
Could also be an oil seal on the compressor side of the turbo being stuffed, and your oil gallery is being pressurised.
Looked at a 2.8TD Jackaroo with that problem- EVERY single oil seak and gasket was weeping from it.
Posted: Sat Jan 05, 2008 6:53 pm
by tweak'e
you did remember to change the breather line ??
Posted: Sat Jan 05, 2008 7:51 pm
by lux2.8
yeah i did change the breather line to pre turbo
Posted: Sat Jan 05, 2008 8:26 pm
by tweak'e
where did you take the oil feed for the turbo from?
wheres the oil outlet go to ?
Posted: Sat Jan 05, 2008 8:40 pm
by lux2.8
oil feed is from alternator feed and drain is from the alternator drain i got info of a amercian site which had a link here just used t pieces
Posted: Sun Jan 06, 2008 9:10 pm
by thebrunks
I use a t piece off the oil pressure sensor for oil supply & return it to the sump where the vacuum pump return is.