Page 1 of 1
Rim compatability .
Posted: Mon Jan 26, 2004 7:17 pm
by Dozoor
Just wondering , After a set of 16" rims for Gq nissan patern .
16x7 ,16x8 --
which rims are of the same stud patern, More offset would be good but not a real important ,
80 series ? More offset or less ?
Posted: Mon Jan 26, 2004 8:01 pm
by Area54
The 75 Series rim has the largest offset of any production rim off the shelf in an eight inch width.
Posted: Mon Jan 26, 2004 10:00 pm
by Dozoor
These are 16s -54 ,
Posted: Tue Jan 27, 2004 12:36 am
by MQ080
Dozoor wrote:These are 16s -54 ,
-54 offset?!?!
I think the largest avaliable before custom is a -44 on a 15x10
toyotas also run a lower offset (stick out further) than nissans, except for IFS models
Posted: Tue Jan 27, 2004 12:20 pm
by Area54
Dozoor wrote:These are 16s
You can get 16 inch rims for the 7# series cruisers, and they have the same 6 stud by 5.5inch pattern. This is the largest offset (wider track) rim you can buy off the shelf in a mass produced 8 inch rim.
Posted: Tue Jan 27, 2004 4:30 pm
by Dozoor
Mq referering to Area 54
Thanks 54.
Posted: Tue Jan 27, 2004 9:08 pm
by blu125
Watch centre bore sizing - TLC 108mm - NisPat 110mm