Bump Stop Mounting Holes < Help Needed
Posted: Wed Jan 16, 2008 10:11 pm
Hi all,
Probably a weird question, but I was wondering if anybody has access to the bump stop mount on the rear of a Gen II Paj. (shown in the pic below). I’m really just after the position of the mounting bolts so I can copy them for a part I have to make up. I have tried getting the measurements off mine but with no body lift I can not get an accurate reading. I tried earlier today (at a wreckers) to lever the body off the mounts but was fairly unsuccessful.
If someone with access to this part was kind enough to take a couple readings for me I would be forever grateful.
Assuming it’s an equilateral triangle, I need the length of each side. I.e. centre to centre measurements. I’m attempting to use the same holes to mount my part, so I need to be pretty spot-on with my drawings. The measurements I got today were useless.
Thanks Heaps
Dave
--
Probably a weird question, but I was wondering if anybody has access to the bump stop mount on the rear of a Gen II Paj. (shown in the pic below). I’m really just after the position of the mounting bolts so I can copy them for a part I have to make up. I have tried getting the measurements off mine but with no body lift I can not get an accurate reading. I tried earlier today (at a wreckers) to lever the body off the mounts but was fairly unsuccessful.
If someone with access to this part was kind enough to take a couple readings for me I would be forever grateful.
Assuming it’s an equilateral triangle, I need the length of each side. I.e. centre to centre measurements. I’m attempting to use the same holes to mount my part, so I need to be pretty spot-on with my drawings. The measurements I got today were useless.
Thanks Heaps
Dave
--