Outer Limits 4x4 Board

Any of you guys and girls ever had dealings with lukey (ozi brand) Ihave seen the pic of the headers they make and it is a nice 4-2-1 desighn wich should boost low rev power. Never heard of them before. NZ$281 wich is not half bad. What was the cost of the huricanes guys and are they 4-1 or 4-2-1 as I have 4-1 on at the moment but I want the low end power its not a dragster so the 4-1 is a bit of a misfit.

Yoda, are you sure the Lukey's are 4-2-1? Kent's got them on his USA Rocky and said they were 4-1, he posted a pic of them on here somewhere...

Hurricanes are 4-2-1 I posted pics of them on here a couple of weeks ago. I paid around $280 AUS including 10%GST.

jep spoke to the guy today had one in stock look under daihetsu feroza it shows a picture
http://www.partsco.com

Whoa!

I just checked that site and can tell you for sure that pic isn't of the Lukey headers to fit a Feroza!



For a start Lukeys are coated in some special black heat resistant paint, and they're chrome. The spacing is all wrong for the exhaust ports too- check the pic below of my Hurricanes for a comparison:



Finally, here's the pic of Kent's Lukeys (complete with Lukey badge) and they're definitely 4-1. So unless Lukey make two different sets of headers for Feroza's that joint is feeding you a load of bull****!

PS: Yoda, go back to the Partsco site and get the Feroza extractor page up, then click on the Rocky page........ the picture doesn't change!

The picture of the Extractors on www.PartsCo.Com are for the Rocky Diesel. (I must fix that).

Here is a bad picture of the Lukey Feroza LPH601 Extractors.

Hi Rock, thanks for the pic.

They look like 4-1, the same a Kent's pic above??? (although it is a bit hard to tell from that angle?)

I realy hope you guys are wrong about this. Does anyone have huricane's web page. PLEASE before I kill a salesman

Liverpool Exhaust in Sydney make them. They don't have an Email address on their website though- Simply PV has been through all that......