What is the practical difference between these?
I noticed that on a VN Commo fuse block, in the engine bay, there's a fusible link (40A) for headlights, and then there are low and high beam blade fuses as well. This is a puzzle to me as I can't think of a reason to have both.
Just wondering where you would use which, and why. I always got the impression that fusible links tended to be used for 30+ amps, and fuses for less, but that doesn't seem to be the whole story.
Anyone got some tips on this?
Jason
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Fusible links and fuses
Moderator: -Scott-
Fusible links and fuses
This is not legal advice.
Fusible kinks take longer to blow than fuses and are better for high start up currents, ie all lights would be one one fusible link, with individual fuses to protect the individual wires.
So 2 x 100 watt high beams + 2 65 watt high beams + parking lights at 4 x ~20 watt, would be run off the 40 amp fusible link, with individual lower rated fuses protecting the "tentacles" of the loom in the event of a short whilst not adversely affecting the rest of the lighting. The cold current of the high beams (easily double the hot current) would probably stress a similar rated fuse in that situation to the point of failure after a few cycles.
So 2 x 100 watt high beams + 2 65 watt high beams + parking lights at 4 x ~20 watt, would be run off the 40 amp fusible link, with individual lower rated fuses protecting the "tentacles" of the loom in the event of a short whilst not adversely affecting the rest of the lighting. The cold current of the high beams (easily double the hot current) would probably stress a similar rated fuse in that situation to the point of failure after a few cycles.
George Carlin, an American Comedian said; "Think of how stupid the average person is, and realise that half of them are stupider than that".
Fusable links , whether wire type or cartridge type ptotect a specific system such as lights , aircon , etc.
Fuses protect the individual devices on the particuliar circuit , say lights , fused rear lights , fused low beam , fused high beam , etc.
Hope that helps , Cheers Paul.
Fuses protect the individual devices on the particuliar circuit , say lights , fused rear lights , fused low beam , fused high beam , etc.
Hope that helps , Cheers Paul.
BLOWNZUK 1.3 efi,sc14 supercharger,hilux diffs,detroit lockers,stage 4 rockhopper,6 point cage,35 muddies.
Who is online
Users browsing this forum: No registered users and 0 guests