How much guard will I need to trim to fit 285/75r16's as I'm only going for a 2" suspension lift and looking at 16x8" rims with a -25 offset and using the flexy flares I have lying around.
If I get the guard trimed and folded to the dotted line in the pic below will that be enough??
Trav
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
How much guard to trim??
Moderator: Micka
How much guard to trim??
'91' Dual Cab Hilux
'07' Suzuki GSX1400
'82' Suzuki PE250Z
What more do I need
'07' Suzuki GSX1400
'82' Suzuki PE250Z
What more do I need
I would think that would be plenty, the back is normally more of a problem. I had 31x10.5s on 8" rims and they touched on the back guards with standard springs, 1" lift cured most of it, 2" was no problem. On the front only needed the ends of the plastic sill trimmed a little.
Yours would be a similar size I would think.
Yours would be a similar size I would think.
Who is online
Users browsing this forum: No registered users and 2 guests