Outer Limits 4x4 Board

OK guys I know this is the wrong time to request a quick response but who wants to run out to their shed and measure the PCD of a NT drive shaft flange, any takers. I'll give you a big thankyou.

outside to outside is 82mm
center to center is 73mm
inside to inside in 65mm
total OD of flange is 90mm
total ID of flange is 42mm
hope that helped

Overall outside diam. is 96mm

some conflicting info there, I have a transfer case that has been drill to suit NT but is not accurate. The 73 PCD I would say would be the one, WT is 85 PCD

I'm sure my measurements are correct but could someone clear this up please.

OK, this could prove to be an issue then. What about 1.0lt's did they have a different PCD.

This is get very complex now.

if its a sierra transfer case , you dont have to drill anything after the 82 model as the flanges are interchangeable , if the flanges are original , you can usually tell from the old flange pattern and bolt hole sizes what the transfer case originally belonged to .

Cheers, I'm just trying to make my drive shaft spacers interchangeable between WT and NT, I know the PCD's are different but I have vary responces about the what is what, there must be three different flanges out there, so I assume the 1.0lt must be different again. but what is what

between wt and nt there is also the bolt size difference.

8mm in the nt and 10mm i think on the wt.