Page 1 of 1

missing 16V parts

Posted: Thu Feb 28, 2008 10:41 pm
by t_e_z_a
Hello,

I bought a vitara wreck with 1.6efi engine to put in the zook.

However it is missing a few parts so I had a few questions.

The dizzy is missing .. Will any G16 dizzy fit (8v carby or 16v efi)? or even pushing it the 1.3 carby one? if not are there any identifying marks on the efi one or extra bits i an notice when looking for one at the wreckers? I saw one today but it only had g16 written on it so i didnt get it just in case.

The alternator is missing (i think bracket is there)... do i need to use the vitara ones or can i use the sierra one ... or an alternative?

The exhaust was missing (am getting extractor anyway) so i will need an o2 sensor. Do i need to get a specific one or are they generic?

The timing case is broken, can you get new ones? if so where?

The fan is missing ... can i use the 1.3L fan or should i just get a thermo?

Thanks in advance

Terrence

Re: missing 16V parts

Posted: Fri Feb 29, 2008 9:58 am
by want33s
*Not sure about the dizzy.

*EF Falcon alt almost bolts straight on and is much bigger in capacity and cheaper than a Zook alt.

*Check to see if you have a 1, 2 or 3 wire O2 sensor.

*Timing cover.... www.lowrangeoffroad.com US$27
Image
*Thermo fan/s will not do anywhere near the same job as an engine driven fan and shroud.

Posted: Fri Feb 29, 2008 1:26 pm
by benjamin78au
is it the dizzy coveror all of it. if you change the button and cap you can get away with a swift.

Posted: Fri Feb 29, 2008 4:23 pm
by t_e_z_a
looks like i have the bottom bracket for the alt not the long adjustable bit. Do i need to get one or can i make one up from steel?

The whole dizzy is missing (hole in back of head and no leads from coil to engine). What models of swift can i get it out of?

Can I use the original fan and shroud and radiator of the 1.3?

There was a plug hanging down near where the exhust would have been ... it was a four point connector but only had three wires going into it. The connector had a black sorround with orange internals... the colours on the wires dont line up with heated oxygen sensor on the wiring diagram i have though.