Page 1 of 1
Tricks for removing needle bearing from tcase output?
Posted: Wed Mar 12, 2008 1:36 pm
by HedgeBoar
Just stripping down my transfer case to put some 6.5:1 gears in...
not having much luck getting the small needle bearing out of the front end of the output shaft, does anyone know any tricks to try with this?
Cheers.
Posted: Wed Mar 12, 2008 4:17 pm
by GRPABT1
Hydraulic press? Bearing puller?
Posted: Wed Mar 12, 2008 4:19 pm
by MUD-PIGSIERRA
Posted: Wed Mar 12, 2008 4:31 pm
by want33s
I used bent tipped circlip pliers.
Posted: Wed Mar 12, 2008 5:13 pm
by v6hilux
Grease and displacement, you work it out!
Posted: Thu Mar 13, 2008 5:39 am
by HedgeBoar
yeah tried the circlip pliers and the grease method, along with a bit if slide hammer action..... with no luck. seems to be very stuck. Might just have to bite the bullet and take it to someone with the correct puller i guess...
Cheers.
Posted: Thu Mar 13, 2008 11:37 am
by HedgeBoar
Got it in the end with another attempt at the grease/punch trick
