Outer Limits 4x4 Board

it used to idle on 800rpm now about 300rpm hard to start. all the gears when going rev out to 4500 rpm or more but 5th gears will only rev to apprax 2000 to 2500 rpm witch is 80 to 90 kph sometimes when warm after 20 min it itll rev out to 3000 to 3500 approx 100
it is also using heaps more fuel any ideas would be helpful
it is a feroza with a applause motor in it with efi

Give us a hint as to what "IT" is and we might be able to help.

If its a Feroza as per your avatar check the diagnostic codes as a first step - its been covered many times and a search of the FAQ will turn up heaps of help.

Manuals can be downloaded as well. WARFS.ORG is a good place to start.

gonezoe wrote:it used to idle on 800rpm now about 300rpm hard to start. all the gears when going rev out to 4500 rpm or more but 5th gears will only rev to apprax 2000 to 2500 rpm witch is 80 to 90 kph sometimes when warm after 20 min it itll rev out to 3000 to 3500 approx 100
it is also using heaps more fuel any ideas would be helpful
it is a feroza with a applause motor in it

Sir is your F300 Feroza an EFi or the carb?

All Australian feroza's were EFI.

Steve.

Gwagensteve wrote:All Australian feroza's were EFI.

Steve.

Sir, refer to the F300 workshop manual.

WTF?

I am sure that there were carby Feroza's sold in other parts of the world, such as the Phillipines, but in Australia, all Feroza's were EFI.

Steve.

my idle isnt fluctuating like most the post plus my problem with power only start in fith gear no other gear thank you

So is it a Feroza ?

He's edited MM - Feroza with an applause motor in it.

Run trouble codes. (The Check Engine light is connected, right?)

Check exhaust for blockeages

Check for vacuum leaks

Check timing

Steve.

engine check light not sure? a engine light comes on when start
exhaust seems ok
not sure about timing motor seems to be running properly all ok in other gears and powerful until put it in fith ill check timing
how do u run trouble codes
seems no leakages around vacuum hoses

thanks for ideas
the engine check light bulb was blown thats why it wasnt showing
run check codes came up with 4 and found temp sensor not connected fixed light problem
exhaust seams not to blocked
couldnt find any vacuum leaks either
ill keep checking other things
couldnt get the oxygen sensor off soaking wd40 around it
at least it starts first go now
thanks againg fellas

fixed again it was the key for timing pulley it was 45 deg out replaced pulley and key and had a bodgey fuseable link didnt help any

thanks mighty for help and info