Page 1 of 1
HJ60 air con layout with image
Posted: Tue Feb 10, 2004 12:51 pm
by glenxr650
I have fitted an original a/c kit supplied from a wrecker. When I install the belt it cannot be tensioned since it is too long. I measured an original belt and it is also too long. Am I missing an additional tension pulley?
The attached image is the arrangement I have:
Posted: Tue Feb 10, 2004 2:42 pm
by glenxr650
I'd better spend some time in the test section and practice on attaching an image!
Posted: Tue Feb 10, 2004 3:51 pm
by bj on roids
email me the image!
Posted: Tue Feb 10, 2004 3:52 pm
by donk
From memory on a 2H the belt goes crankshaft-compressor-ajustable idler-additional pully that was fitted to the water pump behind fluid coupling- back to crankshaft
I am only 99% sure this is correct as it is a long time since i fitted an a/c to one of these rockets
Email it to me as well if you want to
sylviadon@hotmail.com & i will have a look
Regards Don
Posted: Wed Feb 11, 2004 7:35 am
by glenxr650
hope this works
Posted: Wed Feb 11, 2004 8:03 am
by bj on roids
That is how mine is
Posted: Wed Feb 11, 2004 9:22 am
by carts
Yep, thats exactly the 2h layout. If you want I can get the belt numbers off the belt for you this afternoon when i get home from work, just to make sure you have the right belt. I replaced them recently, and repco's numbers on the system were wrong. Perhaps someone gave you the wrong belt along the way.
Posted: Wed Feb 11, 2004 9:39 am
by glenxr650
If you could get me the belt numbers that would be great. I think someone has given me the wrong belt from the start.