Outer Limits 4x4 Board

Posted: **Fri Apr 04, 2008 4:37 pm**

hey im after a rear disconnect for my buggy
have a lt230 t/case is there anyone around that makes one
if so any price?

any help would be great

thanks kane

Posted: **Fri Apr 04, 2008 5:30 pm**

Damien @ Yuri 4x4

Posted: **Fri Apr 04, 2008 5:46 pm**

Strange Rover wrote:
ISUZUROVER wrote:When I had FWH on the front of my IIA I found absolutely NO difference if I had the hubs locked or unlocked on the road.

I think toy drivers may notice a difference because the grease-lubed CVs produce more drag???

Sam - I hear rumours of a rear disconnect you have developed - any more info???
Yea - I posted some stuff on pirate. Sam Keck at Overkill Engineering can make them - he has made a couple for me plus some others for customers. Sam can basically make the whole conversion for a little bit more than I can get a shaft made. Links here - http://www.pirate4x4.com/forum/showthre ... 6&posted=1
Really cool mod though cause its really simple in the end, works really and uses LT95 parts. I had been thinking of lots of differnet ways to do a rear disconnect over the last few years and this way finally came to me...told Sam Keck about it and, and presto, had it a week later.

At this point I think is really only suits buggies cause you lose the handbrake and also the speedo drive as well. Im sure If sombody was really keen you could put these bits back in but Im not sure if this sort of thing is really worthwile in a road/trail rig.

Initially I thought about putting this into the series 1 but Im thinking that staying full time is probably more worthwhile. Being able to unlock the centre diff while crawling the front end up vertical stuff is very, very useful. And then its simply a matter of just unlocking the centre and riding the handbrake to tighten turnes if necessary. You really dont get to do full on front digs but for a trail machine you probably dont need them.

Sam

Posted: **Sat Apr 05, 2008 8:12 am**

sierrajim wrote:Damien @ Yuri 4x4

WAY!!!!!!!!!!!!!!!!!!!! to pricey.

Posted: **Sat Apr 05, 2008 8:35 am**

yep already had a look at them

kane

Posted: **Sat Apr 05, 2008 10:02 pm**

Mick Garner makes them, I think.

Posted: **Sat Apr 05, 2008 10:37 pm**

definately sam @ overkill he has done a fair few of them and they are bullet proof.

Posted: **Mon Apr 07, 2008 6:24 pm**

bazooked wrote:definately sam @ overkill he has done a fair few of them and they are bullet proof.

He wants it this decade

Posted: **Mon Apr 07, 2008 7:15 pm**

--------------------------------------------------------------------------------

bazooked wrote:
definately sam @ overkill he has done a fair few of them and they are bullet proof.

He wants it this decade

Posted: **Tue Apr 08, 2008 11:53 pm**

Micka wrote:Mick Garner makes them, I think.

To much work for the $ but you could ask Mick G he built mine and it still works

Outer Limits 4x4 Board

rear disconnect lt230 any1 make them??

rear disconnect lt230 any1 make them??