Page 1 of 1
GQ-GU front coil spacers, need specs
Posted: Thu Feb 12, 2004 8:54 am
by A1
As topic says im goin to get some made up and need the specs from some1 that has some lyin around .............
Outside diameter=
inside diameter=
And the height of the lip that locates the coil........................in the middle
Cheers A1
Posted: Thu Feb 12, 2004 10:13 am
by bazzle
I dont like spacers other than to trim up a vehicle. For a few reasons.
but just go out and measure easy to do.
Bazzle
Re: GQ-GU front coil spacers, need specs
Posted: Thu Feb 12, 2004 11:19 am
by Area54
A1MAV wrote:As topic says im goin to get some made up and need the specs from some1 that has some lyin around .............
Outside diameter=
inside diameter=
And the height of the lip that locates the coil........................in the middle
Cheers A1
LOCKY has them for sale, around 30mm tall front and rear, I wouldnt go any higher than this, even in the rear it can get a bit dodgy...
Posted: Thu Feb 12, 2004 3:58 pm
by A1
bazzle wrote:I dont like spacers other than to trim up a vehicle. For a few reasons.
but just go out and measure easy to do.
Bazzle
Geez umm thanx 4 your opinion
and yes it is to trim up the rig seems as tho my tube front is rather heavy ..........
And i asked because i didnt want to go and measure as the vehicle is parked out on the tarmac in bout 35+ degrees and id rather not have 3rd degree burns
Re: GQ-GU front coil spacers, need specs
Posted: Thu Feb 12, 2004 4:10 pm
by A1
Area54 wrote:A1MAV wrote:As topic says im goin to get some made up and need the specs from some1 that has some lyin around .............
Outside diameter=
inside diameter=
And the height of the lip that locates the coil........................in the middle
Cheers A1
LOCKY has them for sale, around 30mm tall front and rear, I wouldnt go any higher than this, even in the rear it can get a bit dodgy...
Cheers 54 im only lookin at a maximum of 25mm ............ and its only a maybe ive already got 2 10mm spacers in the front ,,but these are only the flat variety ie no lip on the inside .........and was gunna replace with just 1 slightly bigga but the larger 1,s seem to be different in size bigga centre hole and have that internal lip ...........
And im goin to a local plastic place that do alot in the body lift area (climax) suspension products ......and see wat they would charge as ive seen the manufactured ones reatail for like 40 bucks each
A1