Page 1 of 1
Ford Xflow temp sender
Posted: Sat Apr 19, 2008 8:30 pm
by Maria
Hi, I am putting a Ford 4.1 lt crossflow engine into my Willys truck. Can any one tell were the temp sender is located on the head, it is a cast iron head, from a XC or XE. I bought a sender from Repco, so it must go somewere.
Thanks
Posted: Sun Apr 20, 2008 7:36 am
by xl7fan
G'day, I have an alloy head XE & it's located at the front R/H down the bottom. May be the same for cast head.
Posted: Sun Apr 20, 2008 9:08 am
by Maria
Thanks we look but it is not.
Posted: Sun Apr 20, 2008 9:42 am
by WOZ
The temp sender is located at the rear of the cyl head on the inlet side and is 1\8bsp thread.
Posted: Mon Apr 21, 2008 8:04 pm
by Maria
Thanks WOZ we will look there. This head seem to not have a sender spot for it. Cast iron head.
Posted: Mon Apr 21, 2008 10:25 pm
by want33s
Posted: Tue Apr 22, 2008 7:45 pm
by Maria
Thanks for picture, will look over the weekend if is there. Cheers, Maria
