Page 1 of 1

Gas Mixers

Posted: Wed Apr 30, 2008 9:36 pm
by wolfengo
Hey all does anyone have gas mixers to fit the old carbie model p76 3.5 engines. Wat im looking for is mixers that bolt straight on the carbie.

Cheers Azza

Posted: Wed Apr 30, 2008 11:25 pm
by cloughy
As in simple mixer rings that bolt between the air bit and the carb, for a complex convertor setup?

I got 2 somewhere I think, $boxabeer ;)

Posted: Thu May 01, 2008 6:56 pm
by wolfengo
Oh Sweet do u have a pic of them cos im pretty sure there the ones and how much would u want for them for???

Cheers Azza

Posted: Thu May 01, 2008 7:35 pm
by cloughy
wolfengo wrote:Oh Sweet do u have a pic of them cos im pretty sure there the ones and how much would u want for them for???

Cheers Azza
cloughy wrote: $boxabeer ;)
No pics, I couldn't be bothered for such a small item :D

Posted: Thu May 01, 2008 8:19 pm
by wolfengo
Its just i live in perth WA thats all.

Posted: Thu May 01, 2008 8:20 pm
by Loanrangie
wolfengo wrote:Oh Sweet do u have a pic of them cos im pretty sure there the ones and how much would u want for them for???

Cheers Azza
They are 1/2 " thick alloy plates with a tube protruding and a perforated internal ring the that dispurses the lpg into the air stream, you also need a Y piece and a complex type converter to go with them.

Posted: Thu May 01, 2008 8:31 pm
by wolfengo
Ive got all the gear just all i need is the gas mixer the place i got gas from they did a bodge job on making the mixers instead of getin the proper ones. There a bunch of idiots that did it.

Posted: Thu May 01, 2008 8:35 pm
by Loanrangie
I tried them but pulled the whole lot off and fitted a holley, the key to getting them to work properly is to set the carbs up so that using vacum you can raise the pistons in the carbs giving better airflow.