Outer Limits 4x4 Board

does any one have a dead g13ba engine around?

i need the con rod bolts to finish a rebuild. i have rang all the wreckers around here and no one has the ba just the a engine.

the rods are the same in both engines , the difference is in the crank in the a and ba

i got some for a sierra g13a ands some for a swift g13ba, you can have either but i would aactuallr recomend you go buy new ones i remember reading somewhere that honda D engine bolts are interchangeble , would have to do some digging across several suzuki forums to be sure

edit: Found it.

Garndi@Redlinegti wrote:Honda 1.2-1.6
Should be : 208-6001
I should say that there not a 100% interference fit on all G13b GTI rods.

Its a strange one, on some they have very very slight play and on other rods they do not.

I have however been using them for years now as have others, such as Suzisport....

NB i also got gti rods so i seems all three are same bolt same application)

pm sent.

if its the same rod bolts why are the do the rods have diffrenent torque settings?

can't get new ones unless i go genuine ($750) or custom.

let me rephrase that

they have the same thread, length and size nut on the end on my b, ba, a conrods i have in the garage. Given that gti rev more and are higher power engines then the bolts must be suitable for a ba.

Garndi deals in chips and other pieces for the gti's so i have faith that it's tried and tested. (on another swift forum other ppl talked about the honda bolts being better as they stand up to the rigors of 1.6l engines )