Outer Limits 4x4 Board

hi, have gq lwb , 6" hd coils , have 40mil packers in rear , and bum still down>>> have the normal mods.. kaymar rear bar, 1xjerry can, 1x wheel carrier, roller draws, and water tank>>>> arb bar 9000k winch>?? sidesteps and rails>>> front sits ok, but rear is down>>> least 30-40mm
has any one have a good spring setup to handle the load...... 6 or 8">???

i have a 6" mannel mega lift kit in a gu wagon , its about 2yrs old now sits great and the ride is good to .i have a far bit of weight all the time to , k-mar bar and wheel carrier, rear draws full with recovery stuff and a 37" spare that weighs 59kgs
the rear sits slightly heigher than the front and level when loaded and towing .
i think the boys at tough-dog (4way suspention) use the same coils ,so try ring either off those 2 .
it sound like you either have the wrong length coil or its way to soft

mudrunna wrote:hi, have gq lwb , 6" hd coils , have 40mil packers in rear , and bum still down>>> have the normal mods.. kaymar rear bar, 1xjerry can, 1x wheel carrier, roller draws, and water tank>>>> arb bar 9000k winch>?? sidesteps and rails>>> front sits ok, but rear is down>>> least 30-40mm
has any one have a good spring setup to handle the load...... 6 or 8">???

take it back to where you had the springs fitted, and show them.. if they are a reputible store they will fix it isspa easy

6" mega-lift coils. toughdog shocks should fix the problem.

Would have to be incorrect springs in the rear.

Al.

You are looking at $185 for the pair including freight for the extra heavy duty rears.

Shane

have found the 6"extra heavy duty dobinsons to sit up higher than everyone elses 7"

Yes that is a good point. I have 3 different Dobinsons rear 6-7" lift coils. You may find that the extra heavy duty rears might be 2" higher then your coils.

On the front stock height is 60-65mm at the bump stop within the coil. What are you sitting at?

Shane

bogged wrote:

mudrunna wrote:hi, have gq lwb , 6" hd coils , have 40mil packers in rear , and bum still down>>> have the normal mods.. kaymar rear bar, 1xjerry can, 1x wheel carrier, roller draws, and water tank>>>> arb bar 9000k winch>?? sidesteps and rails>>> front sits ok, but rear is down>>> least 30-40mm
has any one have a good spring setup to handle the load...... 6 or 8">???

take it back to where you had the springs fitted, and show them.. if they are a reputible store they will fix it isspa easy

X2

j-top paj wrote:

bogged wrote:

mudrunna wrote:hi, have gq lwb , 6" hd coils , have 40mil packers in rear , and bum still down>>> have the normal mods.. kaymar rear bar, 1xjerry can, 1x wheel carrier, roller draws, and water tank>>>> arb bar 9000k winch>?? sidesteps and rails>>> front sits ok, but rear is down>>> least 30-40mm
has any one have a good spring setup to handle the load...... 6 or 8">???

take it back to where you had the springs fitted, and show them.. if they are a reputible store they will fix it isspa easy

X2

X3