Page 1 of 1
stock tail shafts
Posted: Sat Jun 07, 2008 7:39 am
by oj ozzy
how would i go if i use my stock front tail shaft with hilux diffs an 35" tyres. will it snap???
Posted: Sat Jun 07, 2008 8:30 am
by Daisy
I'd be using hilux driveshafts and drilling the transfer case flange to suit.
Posted: Sat Jun 07, 2008 9:08 am
by DAAS KAPITAL
Daisy wrote:I'd be using hilux driveshafts and drilling the transfer case flange to suit.
Got any pics of this - What year lux shaft can you use for a 1tr NT
Posted: Sat Jun 07, 2008 9:14 am
by Gwagensteve
None. Only WT flanges are compatible with Hilux.
oj - if the angles are fine on the front shaft (normally the problem with SPOA with correct caster on the front end) then it will be OK IMHO.
I don't think I've ever seen a driveshaft snap. I've seen the yokes smashed from bad uni's/too much angle though.
Steve.
Posted: Sat Jun 07, 2008 1:44 pm
by MART
I'm running zuk shafts with 35's , no problems , I redrilled hilux diff flanges , plenty of meat there , with wide track flanges , Cheers Paul.