Outer Limits 4x4 Board

i am looking for recomendations on other car seats into an 85 nt for me and the missus to be a bit more comfartable,, more padded and bigger would be good......and easy to bolt in would also help

swift seats work for me, but even they are a rather tight fit, i really think if it is that bad, a zook might not be the right car for you

Yeah agreed, I have swift GTi seats in mine but you will not fit a very big seat in a zook. And prey your missus doesn't see this....

the missus isnt that big lol....but a little bigger seat for me at 6,2 and 125 kgs would be good...thanks guys will have a look for some do they bolt in easy

zoook wrote:the missus isnt that big lol....but a little bigger seat for me at 6,2 and 125 kgs would be good...thanks guys will have a look for some do they bolt in easy

I'm 6"1" and 110 kg. just fitted swift seats, happy so far, easy conversion..
christover

The guy who I bought my zook off was about your measurements and used to race mine with the swift seats in it

My old WT Sierra had VS Commonwhore seats just standard ones with canvas covers over them, might be a little tighter fit on the NT though Im not sure....?

Don't go the Autotechnica or Monza buckets then.
Will be tight on your ar53.

Also with regards to your height, you'll need to do a bit of fabricating when installing the seats to move the slider/rail position backwards. I used the standard rail set up (I'm 5'11' and its borderline being too far forward, even when the seats at its furthest position back). Wants33 did do a decent fabrication for this - there will be pics somewhere on the forum.

PS, Reference to 'cow like missus' in the topic title? That's not nice, hope your missus doesn't read the thread.

vitara seats. bigger, supportive, comfy and roomy.

using the vitara seat rails it gives you a slightly higher driving position which means more leg room. this is ok for a softtop or hightop but might not go too well in a standard hardtop (might fit ok, would need to check)

they are NOT a straight bolt up job, the drivers side front rail mount(in car) needs to be removed so the seat can be bolted through the floor and holes drilled for other mounting holes. (all mounting points are double plated and I used some large washers aswell)

the original seatbelt buckles need to be mounted to the SEAT not the transmission tunnel and they fit better if you swap them from left to right (they can be left in the original position but mounting them to the seat gives a little extra belt length.

Well worth the effort.


PS. have some respect for your wife.