Outer Limits 4x4 Board

about to cut my wagon in to a dule cab just with the flat sheet on the back can any on tell me or have any photos of any steel bracing that has to go in there rhs ect

so the engineers dont have any nasty supprises for me

thanks chris

want to be a wylie wrote:about to cut my wagon in to a dule cab just with the flat sheet on the back can any on tell me or have any photos of any steel bracing that has to go in there rhs ect

so the engineers dont have any nasty supprises for me

thanks chris

i was going to ask the same question but im in qld do i have to got
it engineerd or blue plated 2 make legal in qld thanks

I have done them in the past, most engineers will require a suitable roof support such as a roll cage hoop that the roof and rear sheet affix to or just below the joint. They are less critical of the size of the hoop and the material though in my experience. The best advise is to find an engineer and ask what they require as it varies from one to the next.

Joel

why not speak with the engineer first? logical step isnt it?

guys get onto hammey off the forum. his cut is awsome and approved. his idea is so simple yet so obvious.