Outer Limits 4x4 Board

dose any one know of a good machnice work shop in melbourne around breaside that can do rear axcle seals on a 1988 nissan patrol GQ ST 4.2L
for cheap at all???

if so how much woulds be llooking at ?

to do myself iv only just bought nissan a while ago and i am a lil unsure of the sort of seals i need to do them can anyoine help with this ?
and what sort of dollors are invovled in it?


thanx matthew

No idea mate, but its axle not axcle.

Best bet it to buy a Gregorys manual for your car from Repco or similar and have a read, it will explain what seals to use.

Yeah as Tonka said, or just go down to Repco and tell them ur car and wat u need and they will grab it for ya.
Axle seals are easy.
-Take wheel off
- take brake compnents off
- slide axle out
- replace seal and put everything back in

will take ya a coupla hours!!

I think the seals are only worth somewhere between 10 and 20 bucks each.

Screwy

yeah i have just seen iv spelled it wrong ,


i have gotten a name and number
dave - oz auto 4WD in seaford seem to know his stuff on nissan so i'll give him a buzz and see what he has to say

but yeah manuals 40 bucks from repco was gonna get one some stage

thanks dude for ur help

thanks screwy yeah i wasnt sure like iv done the 85 jackaroo but
first time owning a nissan

thanks for your help

If its the outer seal then new bearings are required.
You need a 20tonne press plus plates and may also need an oxy to expand race.

Try escape off road in Blackburn , Mary st. 9877 0277
Tell Greg Bazzle sent you


Bazzle

if it is bearings in her what sort of dollors am i empecting to dish out

have been told it probly the innner seals which are straight forward

Get someone to go through it with you while you do it youself.. that way you should be set to do it next time..