Page 1 of 1
How to adjust panhard rod on 4" lift
Posted: Sat Jul 05, 2008 10:47 am
by iamgq
HI guys,
I am fitting a adjustable panhard for my 4" lifted GQ.
How do I know if the adjustment is right? Is there any standard measurment?
Thanks
Posted: Sat Jul 05, 2008 11:29 am
by chunderlicious
easiest way is to measure off the chassis onto a part of the diff consistent on both sides ie; disc rotor face etc.
Posted: Sat Jul 05, 2008 3:49 pm
by GQ Bear
What he said above^^
No standard measurement as every 4" lift varies to some degree.
When i fitted mine i attached a ratchet strap to rear axle and chassis to pull diff across, then measured, then fitted, then measured again. Front i jacked driver's side body up with highlift, fitted panhard, lowered, measured, and repeated untill right. Both ends took me about 20mins to fit accurately.
Posted: Sat Jul 05, 2008 5:10 pm
by whitemav
Mine sits slightly to the left so it doesnt take out the wires running down the chassis rail at full flex. Only by 5mm when sitting level.
Posted: Sat Jul 05, 2008 6:07 pm
by chimpboy
Yep, just make the two sides even and it can take a while depending on your panhard design.