Page 1 of 1
water and 60series
Posted: Sun Jul 13, 2008 6:24 pm
by seaeagle
when i go through water in the 60 it has a fit, wont rev kepps stalling when i try to rev it, its 3f on gas with elect. ign. ive looked at the basic stuff but cant find what is causing it. could it be steam?
Posted: Sun Jul 13, 2008 7:28 pm
by johno88
when you say basics what do you mean? is water getting in the dizzy and making it run on less cylinders?
Posted: Mon Jul 14, 2008 5:58 pm
by seaeagle
no water in dizzy. leads all good, it doesnt take long to come good , mabee about 5 mins, i did change it over to petrol and it ran good when i put it back to gas after 3-4kms it coughed and spluttered abit them was ok.
there is a join in the elect. ign. wires but its not looking like its getting wet.
Posted: Mon Jul 14, 2008 6:55 pm
by little rusty
i had the same issues with my landrover disco V8. would show same symptoms but have absolutely no water iunder dizzy cap as far as I could see - actually looked bone dry. However, short spray with WD40 and a wipe out she started first go and has actually ran better!!!
give it a crack