Page 1 of 1

Fj40 not liking hills

Posted: Tue Jul 15, 2008 12:58 pm
by AngryElmo
i have a 1984 fj40 with the 2f motor, it has extractors on in and a 350 holley catbu, when i go up steepish hills it just "stalls" :bad-words:
i then have to wind it over for a few seconds till it starts, it then runs ruff and blows smoke for about 10 seconds...... i have a feeling its the carby float as ive heard of this before but how do you get around it?? or what carby should i change it to to fix this problem

Re: Fj40 not liking hills

Posted: Tue Jul 15, 2008 1:02 pm
by bad_religion_au
AngryElmo wrote:i have a 1984 fj40 with the 2f motor, it has extractors on in and a 350 holley catbu, when i go up steepish hills it just "stalls" :bad-words:
i then have to wind it over for a few seconds till it starts, it then runs ruff and blows smoke for about 10 seconds...... i have a feeling its the carby float as ive heard of this before but how do you get around it?? or what carby should i change it to to fix this problem
standard carb is better on hills than most aftermarket ones. holleys are known to be a pain in the arse.

LPG will solve this issue completely, and be cheaper to run

Posted: Tue Jul 15, 2008 1:23 pm
by little rusty
i was running a holley 4 barrel on a 308 and became quite good at staff recoveries... i would keep the pedal down and if I didn't make it ty going around - it sucks heaps...

Posted: Tue Jul 15, 2008 2:49 pm
by AngryElmo
what sort of problems do u get with the standard carby? am i better to go back to it? i didnt really want to go gas as it is hard to put it where it wont get in the way, tanks under will get knocked about and in the back its in the way and takes up to much room......

Posted: Tue Jul 15, 2008 8:50 pm
by rockcrawler31
replace the existing tank with a gas tank, and run a small reserve just in front of the rear axle if that's all your worried about mate

Posted: Tue Jul 15, 2008 8:57 pm
by Modified Toy
I believe the new generation holley fixed this problem if not go to a carter carby.

Posted: Tue Jul 15, 2008 9:10 pm
by bad_religion_au
standard carbie is good once it's been rebuilt. the seals in em are pretty dodge in some of them.

Tuning them is a little harder i've been told than some of the others.

Gas... you won't understand until you use it. a tank will go between the chassis behind the rear diff. i had mine there for 5 years and they don't get in the way too often, as the leaf springs are around the same area.

but even if they do get knocked... they are strong as. i've had the whole car perched on the tank without a dent...