Iskyenderian cams

Post by **St Jimmy** » Mon Jul 21, 2008 8:48 pm

has anyone used one
as i'm putting quad carbs on soon
i thought i would stick a cam in
make it breath better
So is there a dealer in aus
for them

regards
me

Post by **Harb** » Mon Jul 21, 2008 8:53 pm

Isky Cams are the best.......
They have been around and used in every type of race car in the US and other parts of the world for yonks....

One of the few camshafts around that you can check individual lobe timing and lift on and come up trumps every time......

I would use Isky cams in preference to any other brand, bar none....

do take the time though to run it in.

cheers
Harb

Post by **want33s** » Mon Jul 21, 2008 8:55 pm

No dealers in Aust that i know of.
I'd buy an Aussie cam from Crane Aust or COME racing and get one perfectly matched to YOUR engine not just a Zook engine and have local backup and warranty.

If you are fitting quad carbies (off a bike) you really want a twin cam head so you can adjust each cam individually like in bikes to get the MOST out of it.
Jas.

http://www.cranecams.com.au/
http://www.comeracing.com/products/cams/

Post by **Harb** » Mon Jul 21, 2008 8:56 pm

I forgot.......

not sure about local dealers.......every time I get one I import it from the US directly from Isky, although its been a couple of years since the last one.
I will however be ordering another one shortly for a new project, so I will find out I supose if things have changed

Post by **GRPABT1** » Mon Jul 21, 2008 9:24 pm

I would never bother with an off the shelf cam of any brand, go custom it's not as expensive as you'd think.

Post by **Harb** » Mon Jul 21, 2008 10:00 pm

Isky are the masters of custom cams..... tell the timing and lift you want and it will be supplied.....
Have tried most of the local stuff , and it simply isn't as good.
but I guess its ok if you don't want the import hassles and wait time.....

Post by **St Jimmy** » Tue Jul 22, 2008 9:41 am

heres the info that i found
on the cams
Intake ... ....... Exhaust
Duration:266 deg ... Duration: 266 deg
Cam lift:.330 ... Cam lift: .330
Valve lift:.528 ... Valve lift: .528
Valve Lash(cold):.008... Valve Lash (cold): .010

For those power HAWGs that just have to be the biggest, baddest, fastest rig on the block...
We also offer the ISKY POWER CAM! This is a top end cam which works best at high RPMs. Comes with a new valve spring kit to handle the extra throw from this radical cam. This cam is a dual purpose lift at .414, with a cold valve lash spec of .008-.010, Duration (270) .050 duration (230). This kit comes with new heavy duty valve springs and install components.

Post by **want33s** » Tue Jul 22, 2008 9:47 am

Just remember that with a cam swap.. what you gain in top end you lose in bottom end.
Jas

Outer Limits 4x4 Board

Iskyenderian cams

Iskyenderian cams

Who is online