Page 1 of 1
Brake Proportioning Valves - different between 75 and 80
Posted: Sat Jul 26, 2008 6:13 pm
by jsttry
Just a quick question, are the brake proportioning valves the same between the 75 and 80 series? Only difference I can see is that the rod that goes down to the rear axle is a different angle on the 75 series as its mounted up on the side of the chassis rail.
Can this angle be adjusted?
Posted: Sat Jul 26, 2008 6:35 pm
by dow50r
Who would know?? Im guessing they r thesame inside..but its only a guess
Andrew
Posted: Sun Jul 27, 2008 7:22 am
by rockcrawler31
on mine, it was pretty hard to mount it after the coil conversion and the upper links get in the way of the link rod. is there any reason why i shouldn't just make a bracket that goes above the link rod with a threaded rod to adjust it up and down based on the weight of the truck. Bearing in mind that while it's a ute it will almost always be carrying the same weight now that it's a dedicated play vehicle.