Outer Limits 4x4 Board

can i run my welder off a generator.
i have got no idea never had any thing to do with them before.
im guessing i need one that has a 15 amp out put as my welder has a 15 amp plug or can i just get a new power point.
this is my welder:
http://www.weldmaster.com.au/products-d ... 10&pid=312

would something like this work:
http://cgi.ebay.com.au/GENERATOR-DIESEL ... dZViewItem
any one tried these cheap gennies.

any help muchly appreciated.
thanx
mick

That generator should be fine but the welder only has a 10 minute duty cycle meaning that at full load it is only good for 10 minutes every hour.
Something to think about.
Jas.

all ready have welder.
duty cycle is constant. i dont usualy hold the trigger in for more than 10 mins.
so do you think the genny would be ok.
any ones oppinions.
cheers jas.
mick

welder will... sorry should have a min./rec. kva input.....

for the ones that i run at work.. the small ones are 5.5kva to run just one kempi miniark 180.... runs allday no trouble at all..