Page 1 of 1
stripping a baleno
Posted: Tue Jul 29, 2008 4:42 pm
by nicbeer
Hey,
whats to strip off a baleno that i could use? its a mid 90s G16B dizzy motor.
I am aiming to get the seats (possible fit?)
aiming to also get ECU, any sensors, injectors.
motor has big end issues i believe. (may keep for rebuild for supercharger one day maybe.
Nic
Posted: Tue Jul 29, 2008 5:35 pm
by PCRman
What alt has it got? If its uprated from the vit 50amp it might be easier than the 110A conversion.
If you dont end up wanting the engine let me know. I'm looking for a G16B rebuild project.
Posted: Tue Jul 29, 2008 5:36 pm
by nicbeer
PCRman wrote:What alt has it got? If its uprated from the vit 50amp it might be easier than the 110A conversion.
If you dont end up wanting the engine let me know. I'm looking for a G16B rebuild project.
yeh no probs.
i am going to try get what i can but all depends on how easy to get out.
if getting bottom end will prob do a yank out with the chain block inc box and drop it into the trailer
think all its going to cost me is carton tax.
Posted: Tue Jul 29, 2008 7:08 pm
by MART
What about the harness if its a fuel injected model , Cheers Paul.
Posted: Wed Jul 30, 2008 12:46 pm
by nicbeer
anyone know if u can mod the fwd baleno head with bits off the vitara or are the heads physically different in regards to the angle drive and the water outlets.
also noticed the inlet manifold is different, guessing the bits attached are the same just different direction on there.
Looks like block was cooked so i am going to grab the head upwards + efi gear and ancillaries too.
MART - yeh will try for the harness, depends on where routed may just clip the plugs off at ecu.
PCRMAN - If u want the block let PM me, $100 and u can have the rest of the baleno too:)
cheers