Outer Limits 4x4 Board

i have fit a 1hd fte into my 80 series and am looking for someone who can either wire it up or could make me a loom that i could wire it in with

it is actually very easy to wire up yourself, i layed the loom flat on the floor and traced all the wires from the ecu, to where they go and stripped the rest (lights, junk, ect), they are all the same colors for the same wires between most toyota's. the only problem i had was i didn't hook up a switch in the gearbox and it made the engine doughy, once hooked up it went fine.

cheers mark

well i finally got motor going just have two small probs
1. The motor shuts down when driving down the highway and i take my foot off the accelerator, it will free rev and back off no worries it is just when going down the highway
2. the tacho, can i just connect the 80 tacho wire to the wire from the fuel pump. if so will this have an effect on the ecu?
if anyone has any information about these two probs i would love to here from them.

i now have it all working fine thanks to those people who helped me out along the way

yellasub wrote:i now have it all working fine thanks to those people who helped me out along the way

Please Please pretty please

Could you post a detailed dump of everything you can think of for us poor nutters considering the same thing?

Was yours from a Wagon needing the key for security etc etc?

Thanx
Paul

all the info i have is in my head and a whole lottal manuals. the motor i used came from a 78 series wihout the immobiliser. basically i used the original 80 loom and pretty much only used the computer to run he injector pump. if you have any specific qS then i will try to help you out. basically in a nut shell the conversion was fairly easy.